Other Glossary and Directions for the Miner Status Page of Antminer Series:.The “Temp(Chip)” indicates the temperature of the chip. The “Temp(PCB)” indicates the temperature of the miner.Two columns of temperature are shown with S9, one is “ Temp(PCB)” and another “ Temp(Chip)“. The “ Miner Status” page of Antminer S9 is different from that of Antminer S7.In the “ Summary” section under the “Miner Status” tap, hash speed is shown.Go back to the page “ Miner Status“, and refresh the page until there is data shown on the page.(Tips: How to Select Cryptocurrency Mining Pools?) You can find more instructions in the “Help” section of your pool. You can find the correct pool address on the pool’s homepage.For example, in the Antpool, the pool address may be:īitcoin: stratum+tcp://:3333 Make sure you mine a certain currency in the right pools.Then click “ Save & Apply” to save the changes. Go to the “ Miner Configuration” page, configure your mining pool address, mining account, miner password etc.Go to the “ Miner Status” page and keep refreshing the page until some data (Speed, miner account, pool etc.) is shown on the page (generally, the miner need a few minutes to start mining).The username and the password are all “ root“. Input the IP address (for example, 192.168.1.2) in your internet browser. Log into the miner configuration page.For how to scan out the IP of the miner, check here: Scan out the IP of the miner on your PC.( Important: If you are using more than one PSUs for the miner, you should power on the PSU which connected to the 6pin port on the little green controller FINALLY).
0 Comments
Leave a Reply. |